Problem with inkscrews operation on Miller tp74

I have a problem with inkmodule operation from the control panel.
Inkscrews don't work on every unit. We have checked fuses in each motor but it seems like the problem is somewhere else.

Machine:
Miller tp74 4 colors
Miller unimatic c3

 

Dear Sir;
Hope you are well
Please test as attached I did indicated:
1) 49G1=+5VDC
2)49G2=+24Vdc
3) Arrow indicating:+5Vdc+12Vdc+24Vdc+12Vdc -12Vdc+15Vdc-15Vdc .
4)you can Monitoring with the Respective Lamp in the section 49A4 -49H1-49H11 attached in the Schematic.
Measure well with a good DMM(digital multimeter).
Any missing Voltages or out tolerances - or+ 0.5% will be faulty, and will cause a Faulty operation in Any board, consequently, Faulty operation in Ink zone regulation Motors.
Use the schematic diagram for console Unimatic C3
However let me know any question

 

Could you give me a full page from this manual or lead me to exactly search because i can't locate the selection and maybe it is not this model of the device. In the attachment i am sending some pictures of the unimatic c3.

Email: oo00krystian00oo@gmail.com
Thank you for your time.

 

Hi Sir:
See his email for excerpts of Console Unimatic C3 Miller
However let me know any question

 

Hi sir
Do you know the type of the monitor of this console is it ega sga or vga
Thanks

 

Normally they use Vga, you can identify by your connector type HD15.

By other side Read the ID plate behind in the Monitor, they identify what
type Monitor is exactly.

Blessing