Ink splatters

We are experencing ink splatters on our DGM 430 tower. We run a sock roller, as our Dampening roller. Any suggestions? We do keep the water low.

 

Does your ink look emulsified? That's usually what causes ink to fling. I know you said you keep your water low.

 

If ink isn't emulsified then check roller settings, could be as simple as a distributor not making good contact until ink builds up and then it's slinging it

 

If the water level is low, it may be an ink quality problem.

 

Could there be a bad vibrator bearing causing the vibrator to hang down?

 

My first point of call would be to check the ink and how hot the room is / outside temperature. This always had a big affect on the ink where I was printing until the controlled the room temperature.

 

On my mark andy 220o I have ink getting on anilox and driping down pan onto cross bar and then down side if press; cant find problem?