press wont run

hi guys im running a komori l26,i was running this morning then press just stopped dead,it will inch and crawl but wont run,no error lights are showing and the oil is full,any ideas

 

How old is it? Does it have a Fujilog-B, usually located in the main C.P. ? If so, check the inputs to see what the problem is. What about the Eyekom? Next time provide the serial number for more detailed help.

 

If it will inch and crawl in 'Tune Up' the problem is likely in the gate safety switch circuit.

 

Early sheet stops press running. But even Eyekom is problem, Eyekom is nothing to do with inch or crawl problem.
Since there is no indication in error lights, there is one possibility, from my experience, try bypass or jumper "Cylinder Preset device' output terminal.
If this works, the internal relay may be defective or some thing to do with that circuit.

 

the cleaning button wasnt pressed by accident was it?