Under ideal flow the float should always be very close or touching the proximity sensor, if you can make sure the flaot is right at the top and in...
Hello Palgolicho, I do not remember the exact description of the LEDs however after you have made the initial checks like Mathew suggested take a...
Hello Junaid, some more info might help, are there red LEDs on the SSK boards? What is their status?
At the back of the back plane where the TSK in plugged in there is a flat cable labelled as PF-MON try removing that the next time you're ink...
The white or something red power plug on the BEK is sometimes the problem, since you have had errors so far apart its not likely that a board is...
A picture of the panel actually help, not really sure if there is a DIPM or just EAK's, could be blown fuses at the power distribution board...
Azr can works in mode 3, the 24v for the valve comes through that 15 pin connector, its just a jumper from within the connector from the 24v line.
How do you know you are not getting the voltage on the valve, where are you testing this on the bench by yourself? Is it an alcosmart azr can? I...
The compacts are notorious for locking up due to low 5VDC on the ZSK, usually wiggling the power connectors on the ZSK and the NTM brings the...
Hi, that is a very old software, get in touch with heidelberg, they will offer you an upgrade to 32.A, an MC7 IPC, probably a new screen, an...
You might need to go into service and pull out the errors from the auxiliary drives
Bad BEK, REK2 or the communication cable it seems. Also make sure the power supplies are lit up green.
Hi, do you hear a click when the valve opens? If you do valve is good, if you dont its probably stuck, sometimes it possible the person who worked...
Hi Chock, I have managed to repair the supply the red light in my particular case was safety shutdown since the 5VDC output rail was at 9VDC...
Hi Chock, I have checked there are no shorts, which fuse are you referring to? I have checked all the fuses, the main 16A fuse and also the on...
