The circuit board that supplies and distributes the power went bad. Had to replace the whole board. It took a very long time to diagnose and...
Looks like your not setting the machine on the right paper setting, which does not allow the toner to fuse properly to the paper. Try increasing...
Increase the secondary transfer voltage. You need to set up a custom paper in the Paper Type Management on the Canon, then edit the settings to...
Sounds like the same problem I have, see my thread on muddy solid colors on the 6010. I believe it is a chronic issue with the 6010/7010
Yes, I am using Fiery and do not use 1200 dpi, as that just makes it worse. Also we calibrate in the 4 step process; engine reset - shading...
My 6010 can not reproduce well a solid color surrounded by black. The inset color will be lighter on one edge and darker on the other edge, or the...
Receiving Imagesetter general error. 2211 No spinner encoder signal. I cycled power and unloaded plate material. Now DPM will not even load...
Black prints light and cloudy on offset paper. It seems the Black density is not dark enough. When I calibrate on Fiery the curves show the black...
Re: stuck vein Paul, how do you free a stuck vein? I found 1 out of the six stuck. Do you think this is enough to cause feeder problems?
