thunderbird press

3000 for the part, yes, 1998 330. Labor is about 8 hours from my quote. You also sell this part?

1998 330 series, we ended up just setting it up by eye with the sheet infeed.

Rubber ring wore off on the operator side belt and we had to replace it. After techs reinstalled shaft the timing was off. Feeder head...

I need to replace this part under my feeder belt and man roland wants $3000USD. Has anyone tried an alternative like neoprene?

Hello, cutter is stuck in cut position and wont move. WE dont have a service manual and was wondering if anyone has one here. THanks!

no one has any idea, ive given up and just put on a new blanket. other press operators are blaming my fountain solution as i am on a...

1998 Man Roland 330 series Label stock mainly auto washers-- conventional ink its always in different areas

that gloss stays even when the blanket is completely dry and yes we tried using water first. it does nothing.

this is after a deglazer treatment and then hit with rejuvenator

Does it happen on all units/colors? Randomly yes Does it happen on all types of paper, uncoated vs coated? Not sure as it only shows on...

im getting it alot on the outside of the printing sheet and occasionally in the print areas. the affected areas are super glosses and...

just buy a komori and all your problems will dissappear

you cant do this on a 300.

yes sometimes first or last roller has a harsher bump than others. its an old press and air cylinders might be weak

form rollers could be bouncing off the plate from gap. have you tried 3mm stripe? also try running with form 1 or 4 completely off.