sorry thats a typo (obviously). 55mm is the minimum cut, it was adjusted by the last engineer to 50mm a few years ago.
Hi Guys The backguage never needs running back to a stop after power-off, it always remembers where it is. The memory is backed up by lithium...
Hi Panos The backgauge will not accept any value less than 50cm because that is the minimum cut
There are usually 3 concealed fuses on the rear of each of the rectifier circuit boards, you can test them by buzzing across the print. One of...
Hi, we have a Polar 55EM we have a strange problem with the backgauge display/controller. The cut position readout is accurate, and we can cut...
Hi, our Stahlfolder won't boot up properly. The screen reports 'error opening Configuration.XML - use default config. file?' I assume this is a...
After the whole episode I'd have been more impressed had Heidelberg used industry-standard drives and controls rather than try to make their own...
Ok, the machine is repaired now, so for the benefit of Jan's enomic concerns, I'll tell you what Heidelberg found. The engineer fitted a new...
I understand your tongue-in-cheek comment, however the boss's decision is final! Ive asked the printer to keep a keen eye on the engineer to see...
Thanks Paul, we're going to get Heidelberg UK in to look at it, as we've wasted enough time trying to fix it ourselves and the print jobs are...
Hi Jan, yes the manager is deciding between Steve and Heidelberg UK at this time. I stripped the BLT right down and simply can't find a fault,...
Thanks for the reply Paul, I've been to the machine today. None of the LEDs on the SVK3 card are lit, except when we operate the guards (middle...
Hello, we have fault code 15-01 on this QM. The fault first appeared during inching & cleaning , the main motor won't kick in, this is a permanent...