You're welcome.
See if the main air pressure has dropped. If not give it a nudge. We had this problem on both of our LS640s but resolved it by increasing the...
Does the toning have a wedge shape to it? (Wider on the edge and tapering off toward the O.S.)
Thanks. It does appear that some plates are more prone to this than others.
How would this look on the sheet? I suspect that it is over the tail edge. Need to check it out. Thanks.
What is the current default setting for the ink charge/oscillation on a 5 year old LS40. Over the years I have heard several but what might the...
We run RO water. There is a bit of feed back on to the water meter rollers on this press. The press next to it has a lot fewer problems with...
Thanks. I've been checking on that and the prep dept. tells me everything is as it should be. May look into it more though. Kind of get the evil...
Some operators seem to have more of it than others. The ones that are pro active witth keeping things clean like dampeners, backcylinders and...
It tends to start at the sides then works in. At one time it would get into the grain of the plate and require new ones to be made on long runs....
The circulator set points are at 60 and is maintained at that temp. Whats the norm out there?
It very well may be. Not pushing the panic button yet. Thanks.
All units will, some more than others. Starts when well into a job 20000+.
We do have units that are toning more consistently than others.