Recent content by Sijo

Dear nimesh silva , sorry for delayed reply. I tried few times as you suggested. 1. W/O N-MS card. when RED button pressed display will glow all lights including memory display Backage display will come after backage calibration Memory display is comming '1 1'...

Dear Silva, Thanks for your valuable suggestions. I checked the battery voltage , Its showing 3.6v. When I removed the N-MS card and switch on the machine the memory display is came as 1 0. I attached some photos for reference.

yes , clamp is working. I am not sure about safety bolt machine number is 4951E49 polar eltromat 72 is the old one who is used by small printing people now. so there is no way to charge much. if we press on relay 1 and 2 on card 24 simultaneously the clutch is working

do u have any idea about polar 72 clutch dc voltage. now when we press the switch knife is not working

Polar Mohr EMC 92 is the model. It has one memory slot. and memory s battery showing 3.7 V

I messaged to NimeshSilva. Didn't get response. What is meant by WPS ? where it is located ? Yesterday I got memory display for few seconds when I down the knife manually. But machine was struck at that time. No buttons working.

This has began when some thing occurred on power supply board. At that time 5 v was missing. when we cleared that problem the measurement display came but the problem limited to memory. have you any idea of power supply section ? can you identify WPS card in this machine

hi , I tried with operating manual, but no way to clear problem. whats next ? now it is working manually by entering every measurements. do you think this problem related to PLC ? This has began when some thing occured on power supply board. At that time 5 v was missing. when we cleared that...

yes, sijovb@gmail.com

do you have operation manual for this machine ? it is very helpful for me

I will share plc no

there is no error messages. when the backage will reach middle portion the display will come and start reading of encoder. but the program selection display will remain blank. if we push the buttons under program selection display there is no response. manual cutting is possible by enter the...

Hi , I have polar mohr. its backage is not comming to front automatically after it touch back position. The other problem is we can't take programs from memory. no display on program select. I hope you can understand the problem

Hi , I have polar mohr. its backage is not comming to front automatically after it touch back position. The other problem is we can't take programs from memory. no display on program select. I hope you can understand the problem