Recent content by Sharpe Image

I was hoping for something a bit smaller as it's only 84 SRA4 sheets for the job. I print these digital so registration can wander slightly.

Hi Would anyone be able to advise on a way to die cut these if possible on a machine, the attached image is of a 350gsm sheet of card SRA4 size (225x320mm) with 35 x individual labels, which measure 35mm square with rounded corners, at the moment I guillotine these down to size 35mm square and...

Hi all I am trying to print black onto black 350gsm card on Xerox DC242, this will then run through a laminator with white laser foil. I am struggling to get the black card through the DC242 it stops on the transfer belt. I'm guessing because it is not seeing a light coloured paper and is seeing...

Hi All I have lost connection to Bustled Fiery, I have the attached screen showing the status of bustled Fiery, I have been told it could be software issue, does anyone know how to install I have the CD's. Dan

No IP conflicts, only computer and printer on network as we moved I had to keep printer in garage, it has slowly been getting worse with connecting through CWS and also launching the Network scanning on the UI on the Xerox 242. I don't think the network cable could be at fault as above the...

Hi All Over the last few days the connection has been dropping out to the fiery from command work station. I now cannot connect and print, the Network scanning option is greyed out. Any ideas Thank you in advance Dan

All sorted it was a developer issue, replaced developer and the latex/plastic cover over the developer housing opening this had perished and got into developer.

Hi All I have a problem on my Xerox Docucolor 242. I have a yellow band running horizontally across the page when printing A4 LEF. I have run the job A4 SEF as it was urgent. The yellow started to get lighter in density but I managed to complete the job. I have now tried printing SRA3 SEF with...

Hi All Every year I have 4000 DL sized raffle tickets to perf. They are on a 170gsm offset stock. They are already printed and numbered. I normally hand perf these with a rotary hand held perforator and a steel rule on a cutting mat. I don't really want to invest in a piece of electronic...

Great thank you, i found it tricky to find exactly where the ROS windows are but gave a clean in that area as per your video. This improved but to be honest there was hardly any toner to be seen like in your video. The main culprit for the Black image concerns was the Fuser, after changing this...