Can you share the fail ID number or screenshoot of message
The lust drive is not available anymore, you must order the latest device or upgrade
When the problem is present only at one station panel control then is a problem with station safety bus, or maybe is just the board where the run...
First Step check the output byte present to energize the coil for the K050 if voltaje present then coil is burned
Phase failure is coming because K050 deenergized in a fast way, it means some safety issue turn off K050, if UWR reacts then we asume it is a...
As you see the error is present in a printing unit, then the list of motors of the POS-CTRL in the following order: 1- circunferential register...
when you get the inverter from manroland normally the disk with parameters are enclosed. if you have buy the inverter in internet you can try to...
the diskette languaje should be betwen 300 to 700 eur, you must contact manroland dealer
when push run for second time , do you hear the brake at main motor released?
have you replaced the encoder mounted at main motor? normally vibration is caused by a defective encoder
good luck with this old CPU.... better to get an upgrade for the central console (leitstand)
you must get the programm and the licence too, the programm alone do not work, to get software and licence is difficult but you can buy an update...
it this machine working before or are you trying to install it without success?
hi Vlatko, did you solve the problem with mechanic position of the sensors, the information already sended by drukman R2dk01.pdf is correct just...
Hi Daniel, Mr. Mendietta already tell you the solution for the 87 error, you must calibrate mechanically the clamp !!! but if the procedure is...