Recent content by Sergey_Ivanov_1963

In the worst-case scenario, the MMC board is faulty. Slot 5

Check board A354/15. Tongenerator

Machine serial number and year of manufacture. And the error screen, please.

Write the slave number

Station 8 is section 5. Try swapping A350/2. If the problem is in the relay board, the error will move to the other section.

Check the operation of B002 in all sections according to the table PU1 288 PU2 12 PU3 96 PU4 180 PU5 264 PU6 348 You also need to check the operation of the B434 sensor - А350/5 8:0 (PU1) and А359/5 2:7

https://www.colorprintingforum.com/attachments/tokovoe_rele_obmotki_vozbuzhdenija-webp.16867/

In my experience, error 24 was resolved by replacing the excitation winding relay.

https://www.baumueller.com/en/download/operation-software-winbass-v-controller-bum-61x-en-gb Try WinBass, it's freely available on Baumuller's website.

If you need instructions, write to email sivanov1963@gmail.com

The PARAFIN program is used for parameterizing inverters and recording parameters. PARAFIN - Programm for setting parameters The programm should be installed on a hard disk. While it is possible, to start it from a floppy disk, access and transfer speeds cause very long waiting times. For...

Please tell me how the problem ended?

Check voltage 24VAC x 3 on Q138