Good morning David, If you are referring to registration between the 2 color units on the press, the only thing that would cause a problem would...
That looks like your rip pc and has nothing to do with the press, for now. The press pc is in the front cabinet on the os lower right.
This is good. Next time you use a plate cleaner, your lube system should reset
15-11 is a mis-communication between the press pc and the ztk board, and can also be the reason for the control panels to be not working properly....
This one is an easy fix, 15-06 is a lubrication failure and can be reset by replacing the grease cartridge under the catwalk. It can be reset in...
Those plugs stay loose. They do not connect to anything
Try to re- seat the X-7 plug ( circled in the picture) I believe it to be on the ZTK board or the one below it check for burn marks on the 2 plug...
Hey Chris, we have been running Indigos for 15 years , currently running a 7900, the ink being the only negative over those years, otherwise...
The actual switches are behind the black guard, if my memory is correct, one is for high pressure turn off, one is for low pressure turn on .
You can verify with SF-56 error 11-02 while the press is running and then stops. The error will disappear when the press re gains pressure....
Behind the guard of the feeder hand crank, down at the bottom of the air tank there are 2 pressure switches. One for periodic moisture release,...
Hi David, it could very well be the encoder that's causing issue but you definitely need to clean and inspect the 3/2 valve before that. Also,...
The flag sensor for the bail bar ( behind the guard for the hand crank) may have become soiled or loose or is out of position, or the bail bar...
Happy to help but need more information. Sheet arrival timing is adjusted with the knob on the lower left, clockwise for advancing and by viewing...
Those wheels should not be turning at all when the press is idling. For both plate on and plate off, there are 2 sets of guide wheels that...
