Recent content by Ricki Mendes

Hi Eric, It sounds like you have a bad laser driver module. If you need one let me no as I can get you one for a good price. Good Luck,

Sounds like you have and air leak. Need to check all of your hoses, compressor, short stroke cylinders, etc. Good luck,

Try replacing the relay, if it will not stay in it is most likely bad.

No it is Rick, I know how to trouble shoot and repair on my own. But if I need to I can always go back and ask for assistance if needed. Never burn down the bridge as you might have to go back over it.

Hi Shane, is everything all set. Let me know if you need anything.

Hi Shane, It has been a while since we talked. I was with APT and you use to buy parts from us. I'm not with them any more but can still offer you a good price on anything you might need for your press. In response to your problem take a look at the SLM boards one is for down and the...

Hi John, Send me your email address so we can talk.

We have both boards in stock and sell them with your board in exchange. Send me and email and I will quote you a price. Regards,

I have LDM for both Classic and Plus models for sale. Send me an email if you are interested. Regards,

Who did you buy the plate material from? They should be able to answer your questions. I have been told that you might have to adjust the lasers with there new material.

Yes, if you have a leak you will have to keep filling up the chiller. The leak can also cause you a lot of other problems so I would get the leak fixed as soon as you can.

Call me, I might have one or can get you information on were you can purchase one. Rick 401 437-8280

Hi Badbradsa, Sent me and email with your contact information and I will get back to you with the information you are looking for. Also just to let you know used/good parts are not that expensive and we have a large inventory for all 3 DI's made. I look forward to hearing from you...

Email me if you are interested in the Air Tech dryer. I have a brand new one that I could sell you are a good price.

There is nothing wrong with recovered rollers if they are done right. Botcher rollers are very good and will last a long time if they are taking care of. I would stay away from Syntac as they do not seem to last as long as other rollers. Hi Anthony, have you fixed your feeder problem yet...