Recent content by PraisedBacchus

Where it should be 5 vol, the voltmeter shows me 4.5/4.6 volts, is that okay?

I tested the power supply (X3) and this is what it should be there.

It was working without problems until it had the turning on problem

The thing is that we are trying to save the actual ZSK, because it's cheaper than buying another one

Also, they used another board with the same EPROM to test the printing machine, and as they told me, it worked. So, because of that I think the problem is the ZSK. What do you think?

I was reading the malfunctions book, and it says that the 3 LEDs I mentioned means the following: Left to right H2 (red): "Ready to run" H3 (green): "Not ready: press" H4 (green): "No ready: water/pneumatic system" All of them are always on when we turn on the printing machine, when they say...

Sorry, I didn't test it well, it has 2.96 V

Yeah, we're sure about that, because every port conection can conect to the board

That was a battery? Didn't know, thank you for that. It has 2.96 volts.

Oh, we did that in 3 opportunities, didn't work

How can I do that?

Hi to everybody. I need help with this printing. When we turn it on, it gets stuck at the logo and doesn't do anything else. Also, looking for the ZSK, it has 3 leds, and we see all of them are on. The board had previous reparation. It's a ZSK 00.781.3385/01 Thanks for the answers.