Recent content by Paulo Ferreira

Hello, the problem is definitely in 1 sensor, we made a jumper in the connection to test and it allowed the paper to pass through.

Steve, would the springs go through the side guide?

I understand, I tell you that we already did the test with the side guides at the maximum size, and the smaller paper so that it passes in the middle, not through the guide (it does not pass over that sensor) it still does not allow printing on a double sheet.

I comment, what we did is identify in the diagram the cables of that sensor, it is connected to AUM 1, we disconnected the black cables that go to terminals 7 and 8, it still cuts through double blades, what could it be?

Could this be the sensor?

Hello, could you help me with this because we tried a lot and still couldn't solve it. When passing the paper on the tape, give the error (double paper). We have already verified all the confirmation and it is relatively fine. Could you tell me what the sensor that detects the double paper would...

It could be solved, the water sector cable was defective.

Hello, thank you for your response, - where are the LVT connections located? under body 4? -Would it be to check the cables of the main cabinet and the CPtronic?

Hello, I am having a problem in the body 4 water system of a 1996 Sm 74, the system has water and we have already verified that the sensor works. which it normally can be. What other problem could it be? It is a machine that was recently installed and is not yet operating.

The problem was solved, it was a sensor that was not straight on the side of the machine, near the perfector.

Only the safety lock on Body 2 marked in the image disappears, the rest do not.

Also in the startup test it shows me errors, the machine still worked that way, but if you like I can send it to you.

We already turn the machine off and on several times!