Regular roller wash should not be an issue as long as it is compatible with you rubber rollers. Heidelberg recommends using FOGRA approved washes.
If the press starts to run before it stops it is possibly a couple of things, I will list them in the order the most likely problem: 1. The...
Exactly what Jan said to do. When the optical eyes are covered with powder they tell the press (ZTK Board) the delivery pile is already up. Hence...
Typically there was a label on the diode with a power value written on it when you bought a new one. The ones that came in the press did not have...
Not unusual...
It is not unusual for the filter to look that way. It is just graphite from the vanes of the pump. The pump is configured correctly , as the shaft...
There are a few things that can cause this: 1. You are printing on uncoated paper. (Tough to fix, try increasing the tack of the ink.) 2. Blanket...
My guess is the gripper bars in the delivery are hitting the delivery jam switch while the plates are loading. This is typically caused by the...
There is not. The plate cylinder is stationary.
Unfortunately I do not. My apologies.
How are you checking that they are leaking? They do not sometimes work and other times not. The Short Stroke Pistons have two directions, you have...
I do not recommend turning the temperature down below 21 C. The cooling system also cools the electronics and can cause condensation on the...
All machines used the same blanket wash rollers.
I'm going from memory here... I think it was 51mm.
Technically the tensioners are self-adjusting, although, using a pin wrench, you can open the gap the spring is in to apply more tension to the...