Paul Bradley's Recent Activity

  1. Paul Bradley replied to the thread Error E01 pressure adjustment unit on Komori printer, please help.

    Can you send me photos of the control boards below the control panel The paper thickness is adjusted by a motor with a position...

    Apr 13, 2024 at 6:22 AM
  2. Paul Bradley replied to the thread Error E01 pressure adjustment unit on Komori printer, please help.

    You do not need to worry about the charge circuit for the super cap this is not where the problem is 4.6V is fine. Did you check that...

    Apr 12, 2024 at 3:09 AM
  3. Paul Bradley replied to the thread Error E01 pressure adjustment unit on Komori printer, please help.

    If the error clears after 3 hours then it could be a power supply check the display in the feeder and delivery there is RS232...

    Apr 11, 2024 at 6:48 AM
  4. Paul Bradley replied to the thread Komori error(C0BA4).

    I assume that you can only inch forward and rev on the 5th unit when on tuneup. If this is the case there is a problem with the safety...

    Apr 11, 2024 at 6:40 AM
  5. Paul Bradley replied to the thread Error E01 pressure adjustment unit on Komori printer, please help.

    The device you have circled on the board is a super capacitor it is used to backup the CMOS RAM and is charged during normal operation...

    Apr 11, 2024 at 5:23 AM
  6. Paul Bradley replied to the thread Error E01 pressure adjustment unit on Komori printer, please help.

    Hi I assume the problem is with the AMR paper thickness Can you adjust the sheet sizes on the feeder and delivery? Is the display on the...

    Apr 11, 2024 at 5:15 AM
  7. Paul Bradley replied to the thread Tachogenerator KG3D-AA.

    Hi What is the problem with the tachogenerator? This is similar in construction to a DC motor so to has carbon brushes you should be...

    Apr 11, 2024 at 5:10 AM