This Heidelberg platen was my first ever printing press, my last one was a Heidelberg SM102 6 colour perfector and a load of different machines in...
Have you tried increasing the distance of the paper from gripper to the opposite edge by one millimeter?
Are you aware that one of the wires is disconnected in that photo?
Does your press have Vario or equivalent hicky picker?
Loose blanket?
Orestes, there are GTO rollers on eBay, just have to find the right size or you can just buy the core and get it covered by your local roller...
Don't know anything about Hamadas and I know metallics should go down first but have you tried switching units?
Do you have a picture of the marks, and show the direction of sheet travel. If it's as you say not perpendicular to the plate cylinder, you can...
I have done of thousands of 4 col work on a 2 colour press mainly a Heidelberg MOZ/P if you scribe register marks on both sides of the sheet to...
If money is not a factor then the SM52 is the best choice.
In an ideal world, paper should be back trimmed, but often times, paper is loaded from a stack straight from the mill and paper will vary in size,...
Well at least you know the fundamentals. The main difference between the KORD and SM 74 is the feeder, on a KORD it is single sheet fed and on the...
It might be the overshoot device in the delivery, try rocking it backwards and forwards?
Your English is fine, I just misunderstood your question. Yes the nip width is something that will differ from press to press, unfortunately, I...
I think it's pretty much 0.004" or 0.1016 mm on any printing press?