Recent content by Newsman

Hey mate i have used the new iGen5 with clear coat spot color at ATP Sydney. The new freeflow interface is really great. I think from the personal view ypu'll need space for two shelves.

Mop will be handy :)

Experienced the same fault....tech applied the grease on the gear and the fault cleared. After a day, the XPE-1-3127 error came back. We had to remove the Fuser motor and the gear. Removing fuser motor is a pain but worth the effort. Faults gone.....happy days!

Try to use thicker stock or score before fold. Check to see if its against the grain direction.

I had the same issue a month ago. PR belt with 001R00611 'R' was faulty batch.

Hey mate.....which is the override cut off switch.Do you have a diagram?

Tell me about it.........we had 3 previous igen operators here. Still our iGen breaks down an average of 2times a week.

"A circuit breaker “trips” or shuts off the electrical flow to protect the circuit from overheating and causing damage--even possibly an electrical fire. So, before you go and flip the switch on again, take a moment to determine what the root cause is of the tripping. The three typical causes...

This

G'day from Sydney...... Theres a red reset button at the back of the developer housing. I think it's the yellow developer. If its tripped try to reset it. It should get you working again.....also you need to check the surrounding temperature. Hope that helps.

No problemo matey, hope it helped. kiaora.

change decurler settings to default.

Check the sensor at 10A and also check the decurler settings.