Recent content by Nart AlSherqatli

Dear All, I have a polar cutter similar to the one in the image. I would like to change the red main switch. To get to it, the 4 screws under the screen must be taken off. Then what? you simply pinch the panel up and out? or are there any back screws hidden holding the panel?

@Mathew

Dear All, In the image attached, a heidelberg I/O module board. My question is, can the plux X4 be used as an input? On the wiring diagram for Speedmaster machines over 2005 modular, the missing sheet detector in perfector is plugged into (1evm4 - on the pin 19 plug x4). Can x4 plug be...

Dear All, The problem was within the festo solenoids below. There was a short in the board inside the unit. I was able to pull the unit out, remove all black festo solenoids. resolder it, and it worked. Thank you all for your time and efforts.

@Adil @CHOCK @Mathew I saw a previous post where @junker1984 said "under cartridge side frame gear side "Likely failed sensor directly under cartridge side frame gear side. Might try wiping off any debris." I can not find it anywhere, can anyone assist?

Dear All, I have a sm52-5-p-L year 2004. with CPtronic 2000. software version 47.4. The blanket washup device on the 4th unit is not even visible. all other units are working fine. I tested the two sensors that are responsible for monitoring the washup device and the washup device gear, and...

Always with the perfect answer adilberg. Thank you for your time, experience and efforts. Ramadan Kareem :)

Can anyone experienced view the attached images and let me know what do these codes indicate. The machine is Sm74-5-di-L The machine is running normally. Nothing is wrong with it.

And

Here you go ..

Has anyone been through this error? Sm52-5-p-L cptronic with IR. The machine suddenly stops and the following error messages show up. The machine runs after the error. It doesnt get blocked. Any suggestions?