Recent content by mrheidelberg

Bump

Bump

Is the ink emulsifying with too much water possibly

Pre damping is the amount of revolutions the machine does before it goes to print & post damping is the same when the machine finishes printing. Enough to make sure plates are clean before print but not over wet (5 to 10 is normally enough) & a few after to make sure plates are clean if removing...

Would you not be setting the keys with ink in the duct so you can see what you are actually setting ?

Ah ok

Was this all ok & checked before you purchased the machine ?

In the UK this is known as shore hardness, with the instrument to measure known as a Durometer.

Do you not have a separate maintainance manual for the machine or a fold out colour lubrication chart

All the relevant grease & oil points are listed in the manual as there are lots of them - daily, weekly, monthly

Hopefully giving them a clean will help solve your issue

Do you mean ....... can anyone please help me with .........

Possibly where the fittings attach to, but i am not sure, sorry

No option to fit shell, so air settings only

Do you not have the operators manual on the CP2000 screen, you should see it in a parts book also.