Replacing the K Dev bias board should solve the problem. Have replaced just about everything else besides the dispensing motor, which I don't...
When putting in a new dev unit it does keep coming up with an error 092-317 ... changing the NVM 762-315 from 3 to 0 does clear the error. This...
I found the following on another website ... "Biggest flaw is with the toner delivery system/developer housings. Here's the issue in a nutshell:...
2 days ago this machine started printing a very faded black (maybe 20%). Have replaced the drum with no difference. Replaced both black toner...
The little chip at the back of the machine had to be reseated. Has PWBA CPL1 written on the little board with a brass plate either side. After...
We start the machine fine, go to print and it asks to replace R3 drum. Put in a new drum and the error remains. Turn machine off and the error is...
Am having the same issue on our Xerox 5065II which is very similar to the DC250. Everything was working fine, disconnected everything and blew...
plate cleaner, plate gum, etch, solvent, roller wash, blanket wash ...
There doesn't seem to be any electrical problems. There is a lever at the front of the press has a graphic on it that shows the slot (groove)...
OK, I feel the sheet is not being detected at all. I can manually engage the solenoid in place and it works fine, numbers ink and turn perfectly....
OK, I have adjusted the form roller for the numbering unit. The problem appears that the impression is not staying on, so the numbering machines...
Having a lot of trouble trying to ink up the numbering machines. Does anyone have a copy of a manual for the number / perf unit for a Itek 985...