Recent content by Mouad

  1. Clamp of my Polar emc 137 not moving up

    Dears, Suddenly, the clamp of my Polar emc 137 stops moving up Has anyone faced this issue before? Best Regards

  2. Knife getting harmed by Polar emc 137 itself

    Hi Mr Chock, The issue was fixed by replacing the blade shim support (see picture attached) Thank you all for your support

  3. Knife getting harmed by Polar emc 137 itself

    Dear Andy Martin, please show me where could I put the shims on the picture

  4. Knife getting harmed by Polar emc 137 itself

    Thank you very much Mr Chock for your concern, could you please send again a more clear attachment, because the one you already sent is not clear, in addition, what do you say by safety blots, where are they located?

  5. Knife getting harmed by Polar emc 137 itself

    Hi Andy Martin, We have just ordered the knife deflection guides we will replace them, but please could you tell us how to set correctly the clamp beam? Thank you in advance for your feedback

  6. Knife getting harmed by Polar emc 137 itself

    Thank you CHOCK for your prompt feedback, I have checked your points, what do you think of the parts 224910 & 224904 (adhesive shim and support)? they could be the origine of my issue?

  7. Knife getting harmed by Polar emc 137 itself

    Dear all, Lately, my Polar emc 137 is damaging every knife we put in place after less than 2 hours of functioning. (see picture attached below) Please advise :)
See more
Back
Top