which board did you change?
Chock: we are so sorry for your loss !
if you input "double image" in search, you can get plenty of answers.
i don't know the CAM for open your delivery grippers is fixed or moveable, if it is moveable and controlled by servo motor, if the servo motor is...
sounds like not delivery gripper issue. check suction roller, may be suction too weak, another thing is checking the fans on top of delivery pile,...
good fix. Thank you for feedback!
please post more images about the image you post before from different angle, does S24 located at feeder OS side?
you said you have S24 cover switch off, where is it located?
I don't have PM46-2 schematics, is it with CPTronics? usually in the pneumatics system, there is pressure sensor at feeder 15B14 (for CD102),...
did you check all IGNTs under the heat sink? the IGBT you have may be very close like attached datasheet. need the guy with knowledge of...
please post clear BLT board image, should be like attached image.
heat sink unit KVT or AVM defective, at first check all IGBTs on the heat sink unit KVT, if any of them shorted, its related drive circuit (small...
please post all INIT-TEST images, what kind main motor do you have, DC main motor or brushless main motor? so you have brushless main motor. there...
above delivery SEK input path and delivery EAK input path are only for SM74/SM102/CD102, i am not sure MOVP-H press those input paths are same as...
please check this: turn off power, push down and lock up E-STOP button on delivery control panel, since this E-STOP button has two NC contacts,...