Recent content by m_alatorre

I forgot to come back to thank you for the reply. We don't usually do this fold so i'll try next time. Moe

Hello, We have a 4 up Stahl folder and usually do small brochures. We tried yesterday a trifold(i hope that's the name of the fold) on a 3 up (6 letter pages brochure) and it started right from the beginning to mark the last page.(see attachment) Could not solve it so we just did 1...

Hi, We have a GTOZ 52 and one day just like that the water pan rollers stopped working. Turned out that it was a burnt fuze in the electric box(one that looks very similar to those used in home's electric box... at least they use them in mexico) i replaced it and continued working that same...

Hello everyone, We have a used 2007 PM74P. I've using it with no problem until yestarday that we tried the perfector for the first time. I believe that we followed the process from staight to perfecting acording to manual but when finished it showed yellow fault code EFS. I would let me...

Hi everyone, We have a small laminator that we use very little. We've been having a bubble problem lately.(look at the pic) we're laminating coated stock, 250 gsm, offset printed both sides. Film is BOPP base, 28 thickness. We've tried diferent temperatures and/or speeds with no...

Peterh, What i call sheet separator roll(only because that's what OM calls it) is shown in pic 3. In pic 2 you can see the "barrels" that guide the sheet. You can rise or lower the hole bar with adjustment control shown in pic 1 or individually with the nut above each "barrel". OM...

Hi everyone and thanks for the ideas. Finally found it. The sheet separator roll was set too tight. While it did not affected register, it was creating some sort of disturbance by scrubbing powder and accumulating it on that line. One thing that happend is that i switched to the powder we're...

Ill check it today. How do i "silcone" the bar? Grease it? The powder is the same that came with the press. Since it looked the same we got here, i decided to just use it... could it be bad powder?

Hi, Device is a WEKO AP110. I checked the superblue net and it was dirty but no ink buildup in problem area. Very dusty. I vaccum cleaned it. I ran a pile today after this and also moved the starting spray point at 270 degrees and... SAME PROBLEM! I'm gonna move the spray starting to...

Hi everyone, We recently installed a used 2007 PM 74-2-p and everything have been working but i've been having trouble with the anti-setoff powder. It leaves a line of powder across the sheet aprox 1" from the sheet edge.(see pic) Then when running the pile again blanket picks it up forcing...

SORMZ: 2 Colores, Recirculador Royse, Secador Infrarojo, excelente registro. Precio MX $ 525,000.00 AB DICK 9910 XCD: 2 colores, T 51 AE, kompac en unidad principal, polvo antirrepinte (se ve y trabaja como nueva) Precio MX $ 105,000.00 Baum Folder 714 Alimentacion con aire, dos...