What and where is the absocoder? The vericam display does go blank for a couple of seconds and then returns to normal, whenever it goes blank the...
I did check the power at the delivery panel at the speed indicator/display only fluctuating .05 volts 24.04 to 24.09 something like that.
I guess I thought that the press already has one on it and I wanted to locate it and make sure it or the sensor for the timing is not the problem,...
No the problem is electronic, the counter stops for 2 or 3 sheets and speed indicator jumps around and even shows blank the back to the speed the...
A 1998 L-428, electronic counter I think the press has a Varicam that controls the speed indicator and the counter whenever the speed goes out for...
I did happen to see the varicam screen go blank for a few seconds and come back on for alittle bit and do it again cut off for 2 or 3 seconds and...
Just started have the same problems hit and miss.
We are having a problem with the speed jumping around, and the counter freezing/stopping for 2 or 3 sheets and then continuing on and off...
Hello KGM , If I am thinking correctly you might need to re adjust the grippers, if you have operator manual look up setting grippers, there is a...
Hello KGM, We have an L428 was using/loosing alot of oil. inside of all the unit side covers operator side and gear side there are some 2 inch/6cm...
increase the #value to delay the transfer point, if I remember right it is a percentage of the top speed of the press. We have Lithrone 428 I...
Hello Metalheart, Might want to check your delivery gripper bars is the tears on every sheet or every 3rd or 7th? my press has 7 bars in the...
web address for weko www.wekona.com they have contact info there might can email and they can send pdf of operator manual
On our press it's in a compartment behind the control panel for the weko their is a control box that you can set the distance between Gripper bars...