Appears to me that given the condition of the cam, the new follower will not hold up for long. I’d keep a close eye on it.
Given you have determined your pressroom atmosphere is acceptable and your paper vendor is supplying you with quality stock, to start...
Short out memory board after manually restoring positioning. It sounds like you’ve got a thorough handle on restoring press to straight printing...
The follower lever should be "split", allowing you to loosen the clamping on the stud. You also must take the spring load off by raising lever off...
Look for the hollow in the frame which lines up with the follower.
Not a very accurate definition, but ya, we’ll go with that.
Clearly sounds that way. It’s the ring that goes over the drain orifice.
Are you seeing pressure at the manometer? Did the carbon vanes degrade to the point they could be causing blockage?
?electro cabinet control?
Service menus are found when depressing the “wrench” buttons. Though I would guess you need something more specific. But what that is, is unclear.
No cam on gripper bars, those are "cam follower bearings". That said, you may now look for the cam, directly underneath last impression cylinder....
Did you experience a paper jam, which may shift the gear position on the shaft? Excessively worn chains? Do you understand the question “have you...
703 and 704 for press signal originate at LVT box under OS feeder cover on SM74, I don't recall where the taps are on your 72...either in the main...
BAK? No such board in CPC. If you speak of SAK in press cabinet, that would be unlikely cause of issue. Your focus should remain on CPC. Look at...
No connection to CPTronic machine diagnostics. Your problem is within the CPC, or connection of Anphenol plugs. But, as you mentioned all units...
