junker1984
Reaction score
153

Latest activity Postings About

    • junker1984
      No longer necessary? First, did you notice the age of the thread? Secondly, you’re assuming the OP wasn’t dealing with a press that had...
    • junker1984
      Words fail me.
    • junker1984
      junker1984 replied to the thread Heidelberg S-Offset.
      Yes, but that’s a different problem than not raising at all. The most common factor between both problems, I believe, is a failing brake...
    • junker1984
      junker1984 replied to the thread Heidelberg S-Offset.
      I have no books nor schematics anymore. I’m out of the trade. You can certainly purchase through your Heidelberg agency, and it would be...
    • junker1984
      junker1984 replied to the thread Heidelberg S-Offset.
      The switch inside the suction head is only for governing the rsising of feeder head while in production.
    • junker1984
      junker1984 replied to the thread Heidelberg S-Offset.
      The two switches mounted on delivery chain guides, gear side. Those are upper and lower limits.
    • junker1984
      junker1984 replied to the thread Heidelberg S-Offset.
      That is high limit switch, there’s also the one on the top of feeder suction head along with a loose connection of the cable plug in...
    • junker1984
      junker1984 replied to the thread Heidelberg S-Offset.
      Have you checked the delivery pile low limit switch? If failed or stuck, feeder won’t raise
    • junker1984
      junker1984 replied to the thread Heidelberg S-Offset.
      Wrong switch. The switch you’re looking for is inside the feeder suction head. This switch regulates the rsising of the pile. I may have...
    • junker1984
      junker1984 replied to the thread Heidelberg S-Offset.
      In the feeder suction head, have you been examining the correct switch? It’s the switch that the governor foot mechanism contacts under...
    • junker1984
      junker1984 replied to the thread Heidelberg S-Offset.
      The bolt that the switch button contacts is adjustable, up or down. Just because the switch clicks doesn’t mean the contacts are good.
    • junker1984
      junker1984 replied to the thread Heidelberg S-Offset.
      Another critical component to consider is the brake relay, it’s one of the hardest working components in the electrical cabinet. I...
    • junker1984
      junker1984 replied to the thread Heidelberg S-Offset.
      Often times it’s worn contacts in the switch itself, but have you tried raising height of the 8mm “trigger” bolt?
    • junker1984
      I don’t remember the final diameter required for contact (is it 55mm?) you would then subtract 3mm, as the 3M sleeve is 1.5mm thick.
    • junker1984
      junker1984 replied to the thread Electrical error Cd 74-5+LX.
      "Recent installation". Given the machine had been in transit, did you reseat all the boards in all cabinets?
  • Loading…
  • Loading…
Back
Top