Dial indicator will tell you whats going on. We had a press do this, ran compressible blankets but registration was a problem, one day it became...
I once hired a pressman that had come from another company, he was use to long runs, so there wasn't much setup, basically set up and watch it...
Hard to tell but it looks like a label press.. might be a flexo one, don't know the name.
Whats your PH on your water solution? You should be running about 4.5. Reducer is NOT your friend.
Get in contact with this fellow, his name is Rich, knows a lot about Riso. Company name is Green Office Supply. This is a common assy.. too bad...
Go to Riso's website. They have all drivers avail for downloading.
Correct.
On a press with conventional its much easier to get it balanced once the ductor is saturated. On a press with quad flow, tri flow or Dahlgren the...
Your 860s should have either quad flow or tri flow, the 175s had conventional. Anyway, the best way to start up a dry web is to have a very small...
Appreciate the info... trust me, I'm not done with these people.
The problem that we have had since October is still going on. The engineers are "looking into it" So we've had a machine that has not been...
Check with your plate supplier they should be able to point you in the right direction.
Kinda tough to tell but it looks like you printed your film out on a laser printer and tried it as a negative. As a result the light from the...
Yes, we run webs but had the same exact problem. Cheaper but your going to spend more money in adjusting then its worth. We don't run them anymore.
If you have to go with metal, and use film there is no way around. Zante is a very low end machine, there's no way on earth your gonna get that to...