Hello, I have a problem with Horizon Collator TAC A2. The machine can not run and some indicator lamp is turn on. Does anyone have manual book or...
Hi everyone. I have Nagai 116 NCD 6 and have problem. The actual backgauge show different with cutting size. Is there anyone know how to...
I already try and YES, I can get register for unit 1 to 3. For unit 4 it's almost register. I think I should use packing as thin as 0.05 mm....
Yes Rollandman, the front register is perfect now. I already try add or take some packing from blanket. Is it same result if I change packing...
Hi Rolandman, Here the resume of my machine. After try and error for 1 month finally I have to adjust the pin like your advice. The print result...
Hi Rolandman, sorry for not reply soon. I try your advise but it's hard to adjusting pin to "nearly straight" for every unit. The problem is,...
Thank's Rolandman. I will try this.
in that picture now I try to print using unit 1 to 4 and the result is same. For unit 1 I'm using plate unit 5 and brown color. I print 4 color...
print result This is my picture of print result
Oliver 574 EPII have perfector cylinder between unit 1 and 2. So I think if you want to print 4 color that's mean you have to use unit 2, 3, 4,...
To Meny I'm from Indonesia. My machine is secondhand from Japan. I believe that my machine is the only one in Indonesia, so I think no engineer...
I already make plate with ctp 2 times to make sure if plate is good. I already set to "0" position on PQC and check at the machine all the unit...
Well, this is my first time use machine with auto plate changing. Usually I used Heidelberg GTOV 52, Komori Sprint 426, Ryobi 524 and never find...