Where exactly is this valve? I got no water out of either unit of my washup nozzles. Thanks for you time
Thank you for the advice.
So.... In the end I think it was my water the whole time. I cleaned and adjusted everything from scratch. It got a little better, but changing to...
will do.
Same with me. Used Botcher at my last job. Bought a press and rented a building, wtf. Now that I think about it, I may just fix my water problem....
I have a 2007 SM52. Since setup 3 years ago I have been using Tower Millennium 1000 1 step fountain solution. Agfa set me up with plates and...
I believe you were correct, sir. After pulling and checking and re-setting all rollers the print did get a little more open in the reverse lines....
you are correct. I misspoke. It's not really doubling, more like a halo effect. the second photo is my previous run. It's hard to see, but it's there.
Yes, of course. I did, but most all of the suggestions were related to printing unit to unit. I'm only using one unit. Thanks for the reply,...
I am running an SM52. Running 1 unit, I am getting what I think is doubling. At first look it looks like the ink is contaminated from a drip of...
I think I figured it out. The head suckers were set, with the set screw on the bar, angled a little too far forward (away from the press). This...
I'm not sure what I did different, but the indicator on the feeder panel says the sheet is really early. The panel at the delivery says early. The...