Hello, is the manufacturing year from a Horizon machine in the Serial Nr. indicated? Thank you,
I have following issue on this Wohlenberg cutter: When I operate the two push buttons to intialise the cut cycle - The hydraulic clamp goes down...
We have the Problem that the backlight from the TFT screen is defect. There is an small inverter card beside the screen where we saw that the blue...
Hello everybody, i'm searching for the wiring diagram for a Polar 72 CS, Mach. Nr. 5451197 to fix a problem on this machine. The cut cycle will...
Hi Sir, thanks for your reply and your explanations. In the meantime i noticed following status of the machine. First i thought i have a problem...
Hello Everybody, i have a problem with a Polar 72CS standard cutting machine, Nr. 5451197. I can't release the cut cycle while pushing the 2 cut...
Dear all, does anybody have experience with the Error Code 810 'backgauge motor overheated' on the Polar E Series. The machine is working half a...
I have a problem with the correct reference position of a Polar 66. After switching on the machine and reference drive of the backgauge the...