Recent content by Gazbow

Hi, NVM values checked and adjusted so stock came out nice and flat. The thing that threw me, was that when it was jamming continuously it never got passed 8a when the second side was to be printed. However all other stocks running good. Thanks.

The Xerox tech thought it may be around areas 10a, 10b so re cleaned those areas, swapped a couple of the sensors around. I managed to finish the job but still had lots of the same errors and jams. Other stocks runs fine. The 95gsm Silk Matt is a very thin stock I think equivalent to your 63lb...

Hi, I am running Silk Matt 95 gsm, 660mm x 330mm. It ran great for a while and then I keep getting the error XPE-10-1207 LE Late to Duplex Inverter reversing sensor. I have thoroughly cleaned all the rollers and all horseshoe sensors, and the error occurs every time now, so unable to run this...

I mentioned to the engineer about changing the TAB the day before, the streaks didn't look like they were caused electronically more mechanical. So I insisted after reading Marks suggestion. Very handy forum, thanks.

Hi, problem sorted, the TAB blade. After chasing the issue around all the connections, power supplies, I asked the Tech to change the TAB blade and the press is back to normal again. Thanks everyone for your help.

No, the marks appear prior to fusing.

If I run separate sheets with 50% tint of C,M,Y,K the marks are very visible. Starting at the leading edge and fading away to nothing about 100mm from the trailing edge on a sheet which is SRA3 size. The marks are just visible on the 100% C,M,Y,K. If I just change the stock to matt finish and...

Hi, we have a iGen4, diamond edition. It has been printing great up until 2 days ago. After the pressure roll and fuser fluid has been changed, which I doubt has anything to do with the issue. Any gloss coated stock appears with streaks, mostly on the outboard side. Starting at the leading edge...