If you need help finding an SM52-2 I may be able to help you out. If so send me a DM
Its not at all uncommon for these motors to fail in less than a year. As was already mentioned by junker, there are a few variables that the life...
Im guessing that you have a SM52-2 with CP Tronic Compact. Since its a compact machine it does not use SSK boards. Most likely your issue is the...
It’s not normal for a servo to pass the initialization test and then not work afterward. Typically the motor will no longer work if it fails the...
I think you actually mean the blanket cylinder. The blanket cylinder moves via a servo motor not a sensor. Are you having printing pressure...
What do you mean by back cylinder movement?
Your problem be either of 2 problems. First, you must make sure that the circumferential gears are mechanically centered. Do do this, remove the...
When installing the pincer bar, there should be a gap of approx 9mm between the spring loaded gripper and fixed gripper. this is assuming that...
More details needed. Is it a high pile or low pile SM74, also what year is it
Thanks for the tip
Interesting method, so If I understand correctly you are essentially measuring laterally from the edge of the impression cylinder to the edge of...
Hey, as along as the end result is a successful installation, it doesnt matter much how it gets done. Like you said, we all have our own way of...
The new sensor should have come with a small additional cable. It is this cable that replaces the amplifier that your press has. Unplug the...
Your not the only one...
Since the Heidelberg pressing bar on the SM102 is a proprietary tool and not supplied with the machine when new, it is very rare to actually see...