Thanks for the reply. The fuse blows when the key for the lights is turned on.and thats it. We took the switch out to see if they switch was short...
Blowing fuses, does anyone know what F4 and F5 fuses on the board control? I'm blowing fuse f4 immediately after putting power to the cutter....
anyone else? If you've replaced the potentiometer, you would have gotten these same instructions and maybe can help me. All i remember is make a...
Thank you sir, The key pad checks out, I don't see a way to change the calibration from what you posted. The key pad is about 2 inches off what...
By the way, this is TRIUMPH 4850-95 ep. I feel like when I changed to potentiometer, it had instructions to calibrate, I can't find those...
Thanks for the reply. Unfortunately, this is not working either. When i power on holding the cm/inch switch, the screen shows 8888888888 and NOT Test.
What's the diagnostic routine? I replaced the potentiometer. That worked but now have a new problem. Can get the backgage calibrated. It's about 2...
Something to do with the key pad I presume. any ideas. I can't find anything online.
Are you drilling a few, then waiting a bit between sets? if so, it may be like when drilling lamination and you my need to drill some regular...