Thank you, I will translate and relay the message to my co worker
We have a early 2000 CD74 with an extended delivery. Over the years, the gripper fingers have taken a few hits from paper jams and been bent out...
I think were it a jacket issue, the squeeze would be uneven, a contour around the 25 in. format. This is not the case.
We tried increasing the pressure, but it changed nothing. Be it offset or coated stock, the result is the same. Since I added 2 mil. squeeze, the...
We've been using the same box of packing since the beginning, no, I haven't measured it yet.
It is what I suspect. There is also the fact that the automatic water purge on the air compresser wasn't doing its job. I opened the valves...
We have a CD74 with the same problem. It may be due to the floater in the secondary tank sending a faulty signal back to the control panel. The...
When printing a dot screen on any substrate, we get a mottled effect when using 16 mil packing. Back in the beginning of 2016 this wasn't the...
Did this solve your back light issue?
Ours too. Do you know how to change the part and what the part number might be?
I am looking for some reliable used parts in North America for a Heidelberg CD74, notably, an ink roller motor. We had bought one brand new from...
It sounds like we have the same problem, do you mean that the monitor has gone very dim, or is it completely blank? Ours has gone dim, enough that...
Apparently not, just the Ultrasonic sensor, not the side guide sensors.