So you have just proved the brake is not holding during its test. Now you have to find and fix the problem. Did you check the yellow brake...
You need to fix the problem rather than get around it. As Four Finger Ring suggested see if the yellow brake release handle is on the wrong...
That error and your description means your motor brake is slipping. When you press run during the warning beeps power is applied to the motor if...
[ATTACH]
If there are no leaks in the hoses as you say you checked them sometimes it can be the auto air bleeders leaking but more likley it will be the...
The forwarding and lifting suckers maybe clean but if they are worn and you have sideways movement you will have trouble feeding heavier stocks
You could also try and clean the rotary valve on the feeder head - the ports inside sometimes block up. Make sure you mark the hoses
Yes the pneumatic air pressure pushes the piston and this generates hydraulic pressure to open the perfector clamps. Your 235mm measurement is...
If you don't have a caliper just use a long thin screwdriver or the 6mm t bar the press has to adjust the rollers - mark 230mm from the end with a...
Compact memory dump. Turn press off. Put 2 bridges on pins 9-10 & 11-12. Number 1-2 is at the bottom as marked. Bridges are in red. Turn press on...
Eric has a SM74 -6. They do not have sheet compensators they are found on older presses like the MO range. SM74 uses a swing arm gripper...
If you look in your operator manual in the faults section you will see that P22 is a perfector hydraulic pressure fault. If you have never...
P22 is a hydraulic pressure fault in your perfector. So the system is sensing more than 10 bar of pressure while running then it's shutting down....
Well done Richard
Hi Richard By the comments it doesn't sound like you have much experience on perfectors generally this sort of work is done by experienced...
