Recent content by Coloured paper

Maybe the tires are worn out too, or what? There is no paper cutter having a gear box for the backgauge movement. Coloured paper

I would check: Is the shaft inside the blower motor rotating? If not, check the power supply at the motor, maybe by an electrician. If yes, check if you have the icon on the display active, in the moment the air cushion is switched on. If not, check the “ON-switch” underneath the front table. If...

The "ON-switch" is beside the mechanical hand fine adjustment of the backgauge. The "OFF-switch" is one of the cut bottens. The on-off switch in the grey cover is the overload switch. Coloured paper

The overload switch is unterneath the the front table. You don't need to open any cover. Coloured paper

Which machine do you have? Coloured paper

Hallo Wolfgang! Grundsätzlich sollte man das Messer nicht zu tief einsetzen. Wenn das Messer nach dem Messerwechsel zu tief sitzt kann es zu der Fehlermeldung 603 kommen. Das Gleiche kann sein, wenn die Fehlermeldung nach dem Verstellen der Messerstellung (durch den Exzenterbolzen) angezeigt...

No problem. Send me an E-mail address via the conversation

S7 is between S9 and S8. The limit switches from the front to the rear are: S9 limit switch forward movement (no false clamp plate used) - Position at 24-25 mm. S7 changeover from fast to slow. First check S9 and S8. Afterwards make sure S7 is correct activated by the cam. S8 limit switch...

If you see after the reference run the size (backgauge position on the screen), the reference run is finished and okay. In case you have no fast forward speed and slowly only, you have some possible problems: Switch S7 is doing the changeover between slow and fast. The signal from S7 goes...

If I understand you correct, the backgauge moves forward slowly and stops at the reference point (somewhere at approximatally 30 cm). Coloured paper

The reference run in a Polar 115 EMC is an automatically functioning procedure. You switch the machine on and you see the message on the screen. The next step is to activate the backgauge movement by using the hand fine adjustment or the push buttons in the keyboard. Activate the movement...

Hi Robco! There are three hints only. Underneath the front table you have the mains switch, the pressure adjustment knop and the lock valve for the knife change. Get the knife change valve back in normal position. If you do not know which position (of the knop) is for knife change and which one...

Hi Okwonga! On the right side of the machine you have a cover. If you open it, you see right of the hydraulic cylindre a wire. This wire is pulling an encoder called MHS. The error message 603 is from this encoder. The computer does not understand the counting signals or the signal the knife in...

To late - He has his documentation But - Thanks anyway Buntpapier

Молоко - есть только три буквы О. :-) Regarding the drawing and the operating manual I need the machine number. Coloured paper