CHOCK's Recent Activity

  1. CHOCK replied to the thread QMDI46-4 Special function list.

    Hi Shawn: Please review your email Blessing superchock@yandex.com Mobile+WhatsApp:+505 8861 1441

    Jan 19, 2020 at 11:11 AM
  2. CHOCK replied to the thread Manual lithrone 226.

    Hi sir: I have some one Let me know. Blessing superchock@yandex.com Mobile+WhatsApp:+505 8861 1441

    Jan 19, 2020 at 10:49 AM
  3. CHOCK replied to the thread Error 3199 Heidelberg prosetter 74.

    Hi sir: Click the error messages button: following help information is shown, Prosetter 52/74/104 1) Error code 2) Description of error...

    Jan 17, 2020 at 2:20 PM
  4. CHOCK replied to the thread MR R706 trouble 24V.

    ok Blessing superchock@yandex.com Mobile+WhatsApp:+505 8861 1441

    Jan 17, 2020 at 1:45 PM
  5. CHOCK replied to the thread SM 74 Press Stop due to Unknown Cause.

    Hi sir: But you have a main problem with the power supply: 23.59Vdc is faulty power supply is NOT in tolerance, by that reason Sensor...

    Jan 17, 2020 at 10:12 AM
  6. CHOCK replied to the thread SM 74 Press Stop due to Unknown Cause.

    Hi sir: Please test the following: 1) The pressure sensor ”Pneumatic system” 15B14 is fastened to the side frame on the O.S.=+24Vdc....

    Jan 17, 2020 at 9:21 AM
  7. CHOCK replied to the thread heidelberg cp2000 how to adjustment brightness.

    your are welcome Blessing superchock@yandex.com Mobile+WhatsApp:+505 8861 1441

    Jan 16, 2020 at 8:00 AM
  8. CHOCK attached a file to the thread MR R706 trouble 24V.

    Hi sir: 1) Attached is there the Block Diagram for SPS=PLC that you system indicate is faulty with +24Vdc. As you will see, you must...

    PLC=SPS.png Jan 15, 2020 at 1:43 PM
  9. CHOCK replied to the thread Paper Stock Pulling MBM Triumph 5255.

    Hi: 1) Check the cutting stick, when you put a new blade, must be replace the Old cutting stick. 2) Blade Not parallel to the table....

    Jan 15, 2020 at 12:06 PM
  10. CHOCK replied to the thread Paper Stock Pulling MBM Triumph 5255.

    Hi sir: Please do this: 1) The knife and the clamp starts at the same moment. From the construction of the drive gear on the knife motor...

    Jan 15, 2020 at 7:55 AM
  11. CHOCK replied to the thread Speedmaster XL75 touch screen.

    Hi sir: You said before: "I made a screen calibration, at the moment it works normal without problem. Hope it stays this way"?? If...

    Jan 14, 2020 at 6:26 PM