Please swap the two NTM cards and see the reaction? Have you tested the ZSK in another machine?
So please change the ZSK but have you tested the ZSK in another machine? It says that your ZSK has not been repaired properly. In the worst case,...
Please change the battery, I think that's your problem. Thank you, good luck.
Hello dear sir, please check the 3.6 battery.
As I mentioned above, it is the property of Heidelberg and Heidelberg does not sell it. However, you can find out about Heidelberg training. Thank...
Hi sir, it exists but it is owned by Heidelberg and we call it a service point.
also double sheet problems which can prevent the feeder from starting
Hi sir, please change the blanket!
if it's good you could launch the perfect conversion.
Picture
please check your ZSK card, there is a led on the card just at the top see if it flashes red.
checking the oil in the pressure multiplier, then clear the symbol of the perfect at the bottom and proceed to convert the perfect
Hello dear sir, if it's a new installation. it's normal please check if the motor cable and the motor cable of the perfect encoder are connected!
Hello dear sir, what does the machine display on the screen?
I would like to know if the machine was working before the problem occurred or if it is a new installation?
