BEAutomation

sorry for the delay. here is the connection in the ZSK and NTM. for 5 volts. Hope it helps

This looks like is power down during start-up. Check the voltage directly in ZSK2. Is there 5 volts? In the white plug? Sometimes you...

I encounter a problem with this machine arround 2018. But I don't remember having a problem with the diskonChip. Are you 100% sure that...

We are printing company from Bulgaria, if anyone knows any electrical engineer with Schengen visa please write how to contact them or him.

Hello. What do you need?

As far as I remember. diskOn chip it is not so easy to read.

Where do you put the common probe? It looks like you don't have common ground. You have separate windings in the transformer. Also...

Start with checking the eathernet cable from thebIPC to the RGB (REK2) board. Then if it didn't work, swap ESK board with any other...

Incremental encoder defective

What do you mean it doesn't move? The knife is blocked down? Is there an error on the screen? The screen is frozen in cutting mode...

Please sir do that and your issue will be done Switch off the machine ،do this procedure for 30 seconde carefully and switch on the...

I am offering Technical training of KBA 105, 106, P40, RA74, P32. The training is on customer's site and customer's machine to train...

Hi. Anybody can help with Muller martini Amigo perfect binder PLC error problem? The display says " Communication Error. Can't Access...

Did you solve that? I think I can help.

Send me some pictures I might have. But why do you think you need them?