Recent content by Anderson Moreira

  1. IGen4 side one skewing problem

    Hey Milo, Beginning of the year so not too busy at moment. What about you guys?

  2. IGen4 side one skewing problem

    Hi Milo, How r u? I just runned few times the IOI and IOP with the paper size that I had skewing problem. for example one of my paper size is 480x330 mm and runned the IOP with it. regards, Anderson

  3. IGen4 side one skewing problem

    Hi Folks, Happy days!!!! I got my Skewing problem solved. Id like to thank CAignop, CRocket, greg0535, peels, MarkD for all the helps. Regards, Anderson Moreira

  4. IGen4 side one skewing problem

    Hi Folks, Firstly, Thank you so much for all in trying to help me. Well, I have took all the advises posted here but unfortunately, I didn't have any success so far, the side one continually getting skewed around 1 mm off. Looking forward to hear from you guys some new advice. Kind...

  5. IGen4 side one skewing problem

    Hi peels, My paper is miserable too but I have been using so many different type of paper here like glossy, matte and Uncoated too. The tech said in reason of the uncoated paper its almost like self-cleaning but I am going to clean manually one by one asap. Thank you for your help. Regards...

  6. IGen4 side one skewing problem

    Hi greg0535, I had a look under Area 7 and I found a small sheet of paper down there. Also checked the transport path and I didn't find any piece of paper around that. My paper is cut down in house and the paper is truly square. The skewing on paper side one still there and I am solving this...

  7. IGen4 side one skewing problem

    Hi CAignop and greg0535 , Thank you for the help. I will check those things out and let you guys know any news. If anyone had the same problem, Please, do not hesitate to reply to this thread. Kind Regards, Anderson Moreira

  8. IGen4 side one skewing problem

    Hi Folk, I am having a side one skewing problem. I have ran a IOP, IOI, cleaned the glass, sensors, mob sensor calibration and so on. Any Thoughts? Thanks

  9. Polyester film issues

    Hi iGen4_Fiery, The film hasnt any strip along the edges and thats why the sensor didnt pick anything up. Ive glued a white paper on the back along the top and that worked very well. I was just wondering if would have an easier way to do it anyway. Thank you very much for you help. Regards...

  10. Polyester film issues

    Hi Folks, Ive been trying run polyester film A3 size on igen4 but the paper is jamming in the feeder sensor. its all setted up as a transparncy paper, thickness and so on. Does it ring any bells? Regards, Anderson Moreira

  11. Thin Straight Lines

    Hi MarkD, How r u? Im going to talk to my tech Support about it and once again thank you very much for your help. Regards, Anderson Moreira

  12. Thin Straight Lines

    Hi Folks, I got the same problem today running 1000 prints getting a light, short, thin magenta, cyan and sometime black lines over the print on the left side. I thought that was a dirt wire mod and developer housing too but I had cleaned both before running the job and no success at all till...

  13. XPE-09-4113 P1 station 3 Pin Scorotron Fault

    Thanks guys problem solved clieaning all the pinscorotron's and area. Anderson
See more
Back
Top