Recent Content by abdick printer

  1. abdick printer
    Post

    SORM Removal

    By margin head you mean front lays?
    Post by: abdick printer, Apr 9, 2023 in forum: 1-Color and 2-Color Offset Presses
  2. abdick printer
    Post

    SORM Removal

    The flywheel and the feeder head usually move during shipping. I will remove the drive motor so there will be no brakes
    Post by: abdick printer, Apr 9, 2023 in forum: 1-Color and 2-Color Offset Presses
  3. abdick printer
    Thread

    SORM Removal

    Hello fellow printers I'm about to move to a new place. I have to detach a feeder of 1980 SORM. What markings should I make to the magnetic...
    Thread by: abdick printer, Apr 8, 2023, 4 replies, in forum: 1-Color and 2-Color Offset Presses
  4. abdick printer
    Thread

    Stahl k66

    Hello guys I need help operating a k66 stahl folder eg. Fixing double feeding & speed controls
    Thread by: abdick printer, Apr 15, 2021, 0 replies, in forum: Folders
  5. abdick printer
    Post

    plate issue

    Problem solved after replacing the blancket and adjusting the cylinder pressure
    Post by: abdick printer, Jan 29, 2021 in forum: 1-Color and 2-Color Offset Presses
  6. abdick printer
    Post

    plate issue

    Thanks guys
    Post by: abdick printer, Dec 24, 2020 in forum: 1-Color and 2-Color Offset Presses
  7. abdick printer
    Thread

    plate issue

    The plate gets torn out of the machine after about 2K prints. abdick 8810 Any idea about the causes??
    Thread by: abdick printer, Dec 19, 2020, 6 replies, in forum: 1-Color and 2-Color Offset Presses
  8. abdick printer
    Thread

    Abdick miss feed

    Dear fellow printers I have a buckle problem with an Abdick 8810. ( 0 buckle @ no 15 on the buckle dial), which caused feeding problems. Trying to...
    Thread by: abdick printer, Feb 27, 2019, 15 replies, in forum: 1-Color and 2-Color Offset Presses
  9. abdick printer
    Post

    Abdick forms adjustments

    I followed these directions. The form roller reaches the plate cylinder but with little pressure. Problem not solved,I will acquire a new roller....
    Post by: abdick printer, Aug 29, 2018 in forum: 1-Color and 2-Color Offset Presses
  10. abdick printer
    Post

    Abdick forms adjustments

    I can't find the sleeve bearing or the screws that you mentioned. Anyhow there is an allen screw adjustment at the sleeve on the non operator side.
    Post by: abdick printer, Aug 27, 2018 in forum: 1-Color and 2-Color Offset Presses
  11. abdick printer
    Post

    Am Multigraphics plate cylinder clamp

    Yes Mr. CHOCK thats the one.
    Post by: abdick printer, Aug 27, 2018 in forum: 1-Color and 2-Color Offset Presses