"Lack of Water"

Hi and good day! Can anyone pls. help me on how to at least make a remedy by pass on lacking water sensor on PU2 its like a stick plastic material which indicates the level of water or flow... tried every possible way like cleaning it but still no progress i can still run the machine but its always alarming annoyingly... Im runnimg sm-74 6+L machine and hopefully one of you guys can help me...
I think its broken and i need just a remedy to run the machine without the alarming sound so i can still run..
Thank you for your time... ,

 

If you can read schematics, find your level sensor for that unit and run a jumper in the LVT (junction) box from +1 to the proper terminal.

 

Are there any other easy way sir? Can i cut the sensor directly then put some electrical tape on it? Just like that?

 

Hello Eric,
I am not an electric engineer, but even if you make a jumper I prefer to order this sensor, because if there was an actual lack of water then your dampening system will run dry and could cause a damage in your dampening motor.
So make a temporary jumper.
Good luck.