x2f-08-3103

horizontal transport motor failed to start. A1, so i cant run just one feeder unit.

wont get past this. Any idears? did some reseating of some plugs back there, to no avail.

Of course, I'm off half day tomorrow, and have a weekend trip, with much to get done :/ dangit Genny, you have the worst timing!

 

got it going through restarts, reseating plugs.... then it came back yesterday. just reset the error about 20 times, it finally cleared. running again but Im sure it wont be long

 

You sure it's not the transport rollers? Last time I had that error it's because every transport roller on the feeder had an indent in them where they had been resting, producing massive drag on the motor. The yellow rollers are crap. If you have them, order black ones that don't form grooves.

 

yeah its telling me its missing 36 volts on the feeders too. Pretty sure its electrical. it fails to start up...


thanks though! will definitely keep that in mind, Igen is gettin so old

 

this ended up being a board. DSC? dropping 36 volts from a couple ports at random. swapped with A2. works fine

 

Have you tried cleaning all the pins on the board with some de-oxit electronic cleaner and re testing?

 

yep cleaned everything I could get to.

like I said, apparently, just a bad board. Which I kind of figured, when the 36v errors started to move around the different systems... vertical, horizontal, feed....