Heidelberg Stitchmaster ST 100 problems

Discussion in 'Book Binding' started by somerset printer, Oct 27, 2017.

  1. somerset printer

    somerset printer New Member

    Joined:
    May 2012
    Messages:
    1
    Location:
    south west england
    Good morning everyone we have a problem with our Stitchmaster.we have turned on our machine and a battery warning has come up on the screen for the plc Mitsubishi controller. We are going to order a battery for the machine and replace it and have been advised to not switch off the machine. We are still able to operate it but it seems to have lost the use of the inch buttons on the wired remotes but not on the main console and also the position for setting up the stitching in the make ready. We do not have any passwords for the machine so are unable to get to the computer menu to switch anything on or off. The other message that comes up says the jogging function is not on whatever that means means. Can anyone please let us know if they have had similar problems and if possible have any default passwords to try to get to the computer menu. Any help would be most appreciated.
     
    Poval likes this.
  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Good day sir:
    Hi , i was examining his equipment.
    However i would like to know when you are talking PLC Mitsubishie Controller?
    is the control of machine or Converter Driver ?
    I am not clear about that. In the case is Converter Drive you can reprogrammed the same.
    If you have fault in the saddle stitcher, you can do it.
    But if you are talking about PLC ? is little differente, since the software can be corrupted, and need again Reprogrammed.
    The battery is for console or Monitor? if you turn Off the machine you will be lost the Data.
    Maybe you can send me a Pic, how it the controller, my wiring diagrams in normal control, say that you can Do by introducing
    some codes.
     
  3. Poval

    Poval Member

    Joined:
    Jun 2019
    Messages:
    19
    Location:
    Russia
    Hello, we have same problem, did you solve this ?
     
  4. marlon julian magat

    marlon julian magat New Member

    Joined:
    Nov 2021
    Messages:
    1
    Location:
    jeddah saudi arabia
    Good Day, we have a problem with our ST100 Stitch Master, we've replaced new 3.6volts battery of the plc Mitsubishi FX2n-48MT, it was appeared in controller low battery , and its work. when we switch it on the other day the controller system has an error, some data was lost from the plc, we check the programs of the plc and we got a yellow highlighted on ladder diagram. might be need to reprogram the plc. anyone can help for this problem?
     

    Attached Files:


  5. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Hi Sir:

    You must reinstall the Software by The Company, Heidelberg.

    Otherwise must be impossible.

    Blessing
     
Loading...