ncr /lightweight stocks jamming

Discussion in 'Xerox iGen3, iGen4, & iGen5 Digital Presses' started by Swifty2, Oct 9, 2015.

  1. Swifty2

    Swifty2 Senior Member

    Joined:
    Mar 2013
    Messages:
    300
    Location:
    Ma.
    trying to run 14x17 two sided NCR:p:p:p:p:p:p:p
    any tips? corner on inboard side is curling up at p-1 /p-2 causing the jams... been 1hr and have gotten only 4 sellable prints out of a run of 550 :mad:
     
  2. CargoPantsMan

    CargoPantsMan Senior Member

    Joined:
    Apr 2014
    Messages:
    142
    Location:
    Chicago
    Is it getting stuck in the flicker bar at P1 or just flying up in that space between the PR Belt and the fuser?

    I've had some luck in the past with attaching strips of chipboard to the flicker bar to keep the paper flat going into the fuser, but haven't ever tried it with carbonless....
     
  3. Swifty2

    Swifty2 Senior Member

    Joined:
    Mar 2013
    Messages:
    300
    Location:
    Ma.
    flying up!!
     
  4. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    1,113
    Location:
    southeast iowa, usa
    late to the party....

    does it "fly up" over the optical sensor of area 3? (little metal tab at front of vac transport)

    I did like what cargopants did. might have a pic of it.....

    build a "ramp" out of cover stock, taped from PR belt light guard, to RIGHT in front of that sensor.

    note: my problem was 10pt MEGA curly cover. :)
     

  5. Swifty2

    Swifty2 Senior Member

    Joined:
    Mar 2013
    Messages:
    300
    Location:
    Ma.
    left the stock in the paper tray overnite with the heaters on...job ran fine the next day!!
     
Loading...