iGen3 Stacker cart offset question

Discussion in 'Xerox iGen3, iGen4, & iGen5 Digital Presses' started by Mike C, Feb 22, 2013.

  1. Mike C

    Mike C Member

    Joined:
    Feb 2013
    Messages:
    5
    Location:
    MD, USA
    Hi,

    I'm printing a bunch of trays for a mailing and they can't get mixed obviously. Rather than run one, empty stacker, run another, etc, can I get the iGen stacker to offset them where one ends and the next begins? Each tray is a separate file. I've been looking the nvm settings and don't see anything. Seems like an obvious productivity function they would've included, but can it be done and if so how? If not, any suggestions from my brethren as to how you manage something like this? It's a huge "my weekend is gone" type job.

    Thanks!
     
  2. richman

    richman Senior Member

    Joined:
    Nov 2011
    Messages:
    123
    Location:
    Rochester, NY USA
    Set your queue to offset each set and stack, under output-->stacker. I think that's what you're asking.
     
  3. lopeza

    lopeza Senior Member

    Joined:
    May 2012
    Messages:
    56
    Location:
    western ny, usa
    At Queue level select "Output Tab' ----> OFFSET ---->"EACH SET & STACK

    Angel
     

  4. Mike C

    Mike C Member

    Joined:
    Feb 2013
    Messages:
    5
    Location:
    MD, USA
    That worked perfectly, thanks so much. The thing I hadn't tried was doing it at queue level.
     
Loading...