Ghost Jam area 3.

Igen 4.

There was NEVER a jam there, it was sitting idle.... Now, error is there, and will not clear. I've cleaned every sensor (i can see)

am I missing something?

 

Is the sensor aligned with its reflector?
Is there a transport belt covering it? (Had that happen once)
Try pushing the sensor with your finger to move it and see if it clears.

Otherwise, I'd replace the sensor.

 

Bravo!

well done sir! area 3 sensor on the vacuum transport....pushed to left and "popped" over into place.. error cleared. Had to push pretty hard...I didnt feel comfortable doing it...but had nothing to lose

I had just done that came on to post.

it's a good thing too, my mech is on vaca... and I need the Igen tomorrow. I was diggin through bags of sensors LOL

 

Woo hoo! Nice